Products & Services
Precision Products
Multiple Spindle Heads
Lead Screw Feed Tap Units
Drill Units
Working Holding Fixtures
Fixture Columns
Standard Upright Machines
Sales Network
"W" Companies
Wisconsin Machine Tool Corporation

Wisconsin Machine Tool Corporation

3225 Gateway Rd. suite 100

Brookfield, WI 53045

Standard Upright Model TM-415 Vertical Tapping Machine
Standard Features
Optional Equipment
Short Form Specification


S T A N D A R D  F E A T U R E S Back to top
  • Complete base and column
  • Fixture plate with machined keyways and tapped holes
  • Electrical controls with Allen-Bradley programmable controller
  • Wisconsin LSFU-415 tap unit, complete with:
  • Single spindle up to 1”-8NC in steel capacity
  • Hardened and thread ground lead screw and nut
  • All standard pitches, inch and metric, available for lead screw pitch
  • Multiple spindle flanged quill is provided with flange for close coupled multiple spindle head mounting
  • Pre-machined pads to accept optional guide bars and brackets
  • Hardened helical gear drive
  • Spindle speeds from 220 RPM to 1210 RPM
  • 3 HP brake motor, 1700 RPM, TEFC, 230/460 volt, 3 phase, 60 cycle
  • Stroke flexibility is fully adjustable from 0” to 4”. Dial control is located for ease in adjustment
  • Built-in tap protection
  • This product is available in Autocad or DXF format. Consult factory for additional information.

O P T I O N A L   E Q U I P M E N T   Back to top
  • T-slot fixture plate
  • Risers
  • Opto-touch cycle start
  • Coolant system
  • Manual or automatic lubrication system
  • Rapid approach slide
  • Special paint
  • LSFU-415 tap unit optional equipment:
  • Mounted guide bars and brackets
  • Rapid approach slides
  • Removable spindle nose – 3/4", 1-1/16”, 1-3/8” or 1-7/8” ASA or quick-change adapters
  • 5 HP brake motor, 1800 RPM, TEFC, 230/460 volt, 3 phase, 60 cycle
  • Overhead foot mounted motor
  • Tap holders
  • Short cycle stroke
  • Multiple spindle tapping heads – adjustable or fixed spindle available
  • Air counter balance for tapping heads weighing 150 lbs. or more
  • Automatic lube blocks
  • Machine bases, columns and risers
  • Additional lead screw and nut
  • Special paint


W A R R A N T Y Back to top
  • Each tapping unit is two hour cycle tested after assembly to meet our stringent requirements and is backed by the industry’s most comprehensive Two Year Parts Warranty. 


TM-415  S H O R T  F O R M  S P E C I F I C A T I O N S    Back to top


Brake Motor 3 HP (2.25 Kw)
Stroke 4" (102 mm)
Tap Capacity 1" - 8NC Steel (M24 x 3.00)
Spindle Speed 220 to 1210 RPM
Depth Repeatability +/-0.005" (+/-.13 mm)
Cycles Per Minute 10 std. (up to 30 available)
Copyright © 2008 Wisconsin Machine Tool Corporation. All rights reserved.